Dukane 403-570-01 user manual Data Port Connector, Automation Wiring

Dual Servo Spin Welder User’s Manual

Data Port Connector

The computer interface connector is located on the back of the welder above the power switch as shown in Figure A-4. It provides a computer connection to export part data and weld profile graphs. The pin numbers for the connector are shown in Figure A–4.

Automation Wiring

If the Dual Servo Spin Welder will be used in Automation mode, the signals normally generated by the optical switches and abort switch must be reproduced. Figure A-6 shows a wiring diagram and a description of the required signals.

Figure A–4Data Port Connector Location

51

9 6

Figure A–5Data Port Connector Pins

Page  100 Dukane Manual Part No. 403-570-01