Continued
Connecting Speakers
To connect speakers
You can connect the speakers by following the procedure
below: |
|
|
| |
1 |
|
|
| |
2 | Speaker terminals | 3,4 | ||
| SPEAKER IMPEDANCE | Red | ||
|
| MIN 4Ω |
| |
Speaker cord | + | + | Speaker cord | |
R | L | |||
| ||||
|
| |||
| – | – |
| |
|
| Black |
| |
| R |
| L | |
Rear of the right | Rear of the left | |||
speaker |
| speaker | ||
1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.
2Open the speaker terminal.
3Insert the end of the speaker cord to the terminal. Match the polarity: White cord to red (+) terminal and black cord to black
4Close the speaker terminal on the rear of the unit.
Use only speakers with the speaker
To remove the speaker grilles
The speaker grilles are removable.
Holes Projections
Speaker grille
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at the bottom.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
