Section 2 - Safety Considerations
Health and Safety Tips
Please observe these health and safety recommendations for safe, efficient, and
Proper Installation - Do not operate the Dual Servo Spin Welder until after the electrical system is properly installed.
No Unauthorized Modifications - Do not modify your Dual Servo Spin Welder in any way unless authorized to do so by Dukane Corporation. Unauthorized modifications may cause injury to the operator and/ or equipment damage. In addition, unauthorized modifications will void the equipment warranty.
Keep the Sheet Metal Intact - Do not remove any of the protective sheet metal enclosing the motor or controls. The servo motors and drives have exposed electrical terminals which could cause injury or death if touched.
Grounded Electrical Power - Operate this equipment only with a properly grounded electrical connection. Refer to the NEMA Type
Comply with Regulations - You may be required to add accessories to bring the system into compliance with applicable OSHA (Occupational Safety and Health Administration) regulations for machine guarding and noise exposure.
Operate Safely – Keep your hands and body away from the tool head during operation. Always wear a face shield when operating the spin welder. Be extremely careful not to let long sleeves, necklaces or long hair become entangled in the spin welder during operation. Do not operate the welder if under the influence of alcohol or drugs. Read the warning labels on prescriptions to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not operate the machine.
IMPORTANT
Always wear a face shield when operating the welder..
CAUTION
Welded parts may be hot..
IMPORTANT
Never operate the Dual Servo Spin Welder with the protective sheet metal removed.. This is an unsafe practice and can result in injury..
Dukane Manual Part No. | Page |
