Dual Servo Spin Welder User’s Manual
Operational Switches
Emergency Stop Switch
A red Emergency–Stop (E–STOP)switch is located in the center of the base as shown in Figure 4–3. The emergency stop switch must be in its reset position before the operate switches will function. To reset the Emergency Stop, twist the large red button about 45 degrees clockwise, which will cause the button to spring out. This is depicted in Figure 4–4.
Left | Right |
Run | Run |
Switch | Switch |
| Lower Fixture |
E–Stop Switch 
Figure 4–3Operate Switches and E–Stop
| Reset |
to |
Twist | |
POWER | |
INCYCLE | |
T | |
ABOR | |
Figure 4–4Setting and Resetting the E–Stop
Page 24 | Dukane Manual Part No. 403-570-01 |
