Dukane 403-570-01 user manual Unpacking Welder, Packing List, Work Area, Qty Part Number

Section 3 - Unpacking and Setup

Unpacking Welder

The Dual Servo Spin Welder is normally packed in a corrugated carton resting on a wooden shipping pallet. To unpack the welder follow these steps.

1.Remove the straps from the carton.

2.Open the top of the carton. Carefully remove any packing materials, cables and documentation.

3.Cut the tape at the bottom corners and unfold the flaps.

4.Remove the corrugated carton, but leave the welder on the pallet.

5.Leave the power cable wrapped up until after the welder has been placed in its working area and you are ready to begin hooking up power. This will pre- vent accidental kinking or pinching of the power cable.

Packing List

After removing the shipping container, check that you have the items listed in Table 3-I. Inspect the welder for damage. Report any damage immediately to the carrier and to Dukane Ultrasonics Service at (630) 762–4900. Also see Section 11 for information on contacting Dukane. Save all shipping and packing materials so they can be inspected in processing any claims that may arise.

Work Area

Allow sufficient area on either side of the Dual Servo Spin Welder for handling material, work pieces and fixtures. Provide ample room so that the movement of an operator or helper does not interfere with the work of another. Also be aware that under extreme conditions, small droplets of molten plastic may be spun off from the upper part.

Qty	Item	Part Number
		SVT012VR or
1	Dual Servo Spin Welder	SVT032VR or
		SVT042VR
1	Base Interface Cable	200-1124-3 or
		200-1545-01
1	Dual Servo Spin Welder	403-570-XX
	Manual
1	CD with Dual Servo Spin	___
	Welder Utility
Table 3-IDual Servo Spin Welder Packing List

Dukane Manual Part No. 403-570-01 Page  15