Quick Start
To attach the MultiSync LCD monitor to your system, follow these instructions:
1.Turn off the power to your computer.
2.For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the
For the MAC: Connect the Macintosh cable adapter to the computer, then attach the
DVI signal cable
Figure A.1 | Figure A.2 |
Macintosh
Cable Adapter Figure B.1 (not included)
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
3.Remove the connector cover (Figure C.1).
4.Place hands on each side of the monitor to tilt the LCD panel 30 degrees angles and lift up to the highest position (Figure C.2).
5.Connect all cables to the appropriate connectors (Figure C.2).
NOTE: If connecting both DVI and
6. Place the connector cover onto the back cabinet (Figure C.3).
Figure C.1 | DVI Cable |
Figure C.3
Figure C.2
7.For successful cable management, place the cables in this order into the cable management: Power cord and DVI cable (Figure C.4).
8.Place DVI cable and power cord into the specific hooks indicated in Figure C.4.
9.Place the
10.Make sure all cables are resting flat against the stand (Figure C.4).
