Attaching LCD Options
You can attach mounting accessories to the LCD monitor in one of the following two ways:
1. In the upright position
3.Ventilation Requirements for enclosure mounting
To allow heat to disperse, leave space between surrounding objects as shown in the diagram below.
2. Lay the screen face down
Protective Sheet
Table |
Tabletop Stand
4.To prevent the LCD Monitor from falling down
Fasten the LCD monitor to a wall using a cord or chain which is sufficient to support the weight of the LCD monitor (approx. LCD3210 17.0kg).
Before moving the LCD monitor, the cord or chain should be
removed.358mm
Cord or Chain
Clamper | Screw |
|
English
To avoid damaging the screen face, place the protective sheet on the table underneath the LCD. The protective sheet was wrapped around the LCD in the original packaging. Make sure there is nothing on the table that can damage the monitor.
This device cannot be used or installed without the Tabletop Stand or other mounting accessory. For proper installation it is strongly recommended to use a trained, NEC authorized service person. Failure to follow NEC standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding your warranty.
When using mounting accessories other than NEC compliant and approved, they must comply with the
NEC recommends using mounting interface that comply with UL1678 standard in North America.
5. To prevent use of Main Power Switch
To prevent the use of the Main Power Switch, if desired, please attach the Main Power Switch cover which is included as an accessory. NOTE: With the main power switch cover in place, the main power switch can not be turned off. To turn the power off, remove the main power switch cover and turn off the switch, or remove the power cord from the AC Inlet at the back of the monitor.
Main switch cover
Screw
