Setup Procedure
1. Determine the installation location
CAUTION
Installing your LCD display must be done by a qualified techni- cian. Contact your dealer for more information.
CAUTION
MOVING OR INSTALLING THE LCD MONITOR MUST BE DONE BY TWO OR MORE PEOPLE. Failure to follow this caution may result in injury if the LCD monitor falls.
IMPORTANT
Lay the protective sheet, which was wrapped around the LCD moni- tor when it was packaged, beneath the LCD monitor so as not to scratch the panel.
2. Install the remote control batteries
The remote control is powered by 1.5V AA batteries. To install or replace batteries:
1.Press and slide to open the cover.
2.Align the batteries according to the (+) and
3.Replace the cover.
1 Remove the cover | 2 Insert the batteries | 3 Replace the cover |
CAUTION
Incorrect usage of batteries can result in leaks or bursting. NEC recommends the following battery use:
•Place "AA" size batteries matching the + and - signs on each battery to the + and - signs of the battery compartment.
•Do not mix battery brands.
•Do not combine new and old batteries. This can cause a shorten life or liquid leakage of batteries.
•Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment. Don't touch ex- posed battery acid, it cause damage to your skin.
NOTE: If you do not intend to use the Remote Control for a long period, remove the batteries.
3. Connect external equipment (See page
•To protect the connected equipment, turn off the main power before making connections.
•Refer to your equipment user manual.
4. Connect the supplied power cord
•The equipment should be installed close to a power outlet and should be easily accessible.
•Fully insert the prongs into the power outlet socket. Loose con- nection may cause image degradation.
5.Switch on the power of all the attached external equipment
When connected with a computer, switch on the power of the computer first.
6. Operate the attached external equipment
Display the signal on the external equipment you wish.
7. Adjust the sound
Make adjustments when adjustment of the volume is required.
8. Adjust the screen (See pages
Make adjustments when adjustment of the screen display position.
9. Adjust the image (See page
Make adjustments when picture adjustment such as the brightness or contrast is required.
10.When monitor is installed in the portrait position
•Remove the stand (feet).
•Left edge should be upper from front view.
11. When installing the monitor to a wall
How to remove the stand
1.Spread the protective sheet on the flat surface, such as a desk.
2.Place monitor on the protective sheet.
3.Remove 2 screws by screwdriver and place them in a safe place for reuse.
How to install stand
1.Please turn monitor off.
2.Insert claws of monitor to stand holes until clicks.
3.Fasten 2 screws(M5 x 40mm) on both sides of the monitor. Torque 280 ~ 300N•cm.
0
9
