NEC LT150, LT85 manual 32

Adjust the Tilt Foot

1)Lift the front edge of the projector.

2)Press the Tilt button on the top of the projector to extend the adjustable tilt foot (maximum height).

Adjust the Image Using Auto Adjust

The Auto Adjust function automatically optimizes the image in RGB mode.

[Poor picture]

1

L
ECNAC
	R
SELECT	E
	T
	NE

U			ACCESS
N	EM	ADJUST		CARD
		AUTO			PC
					SOURCE
					BY	ON/STAND
	2
						STATUS
						POWER

1

[Normal picture]

3)Press and hold the Tilt button.

4)Lower the front of the projector to the desired height and re- lease the button to lock the Adjustable tilt foot.

There is approximately 5 degrees of up and down adjustment for the front of the projector. The rear foot height can be changed, but the vertical distance from the bottom to the desk or floor should be 0.14 ” (3.5mm) to make the projector horizontal on the flat surface. To fine-adjust the height of the rear foot, re-

move the spacer (black rubber) and rotate the rear foot to the desired height.

*If the projected image does not appear square to the screen then use keystone correction for proper adjustment.

L
ECNAC
	R
SELECT	E
	T
	N
	E

4	U			ACCESS
	N		ADJUST		CARD PC
		EM	AUTO

	SOURCE
	BY	ON/STAND
3
		STATUS
		POWER

4

SOURCE			AUTO
			ADJ.
	U
	N
M	E
		Vol.
		SELECT
E		Vol.			E	L
N				C
T			N
	E
			A
	R
			C

POINTER	PIC.
	MUTE
MAGNIFY

SOURCE

PC	CARD		AUTO
		ADJUST
		ACCESS

E

N

T

E

R

PC	CA
	RD

C

A

S

N

up down

Do not use the tilt-foot for purposes other than originally intended. Misuses such as gripping the tilt-foot or hanging on the wall can cause damage to the projector.

Press the Auto Adjust button to adjust Position-H/V and Pixel Clock/ Phase for an optimal picture. Some signals may not be displayed correctly or take time to switch between sources.

E–29