Upgrading Your System 4-29
Removable Media Devices
A variety of IDE and SCSI removable media devices can be installed in
peripheral bays A, B, C, D, and E. An IDE CD-ROM is always mounted in bay
A. A 3.5-inch diskette drive is always mounted in bay C. Other devices should
be installed in the first available bay from the top (bay B). Contact your sales
representative or dealer for a list of approved devices.
If you are adding or removing an IDE removable media device, consider the
following:
! The system board supports a primary and secondary IDE channel
connector. Each of these supports two devices, for a total of four IDE
devices. Your system includes the primary channel IDE interface cable.
! A first (master) device and a second (slave) device are supported on both
the primary and secondary IDE connector. Jumpers on the device
determine the device configuration, master versus slave. Cable Sense
(CS) device configuration is not supported.
! Your system includes a three-connector IDE cable connecting the CD-
ROM to the system board primary IDE connector. The CD-ROM that
comes with your system is set as the master device. A second IDE
connector is available to connect a slave IDE removable media device.
! If only one device is on an IDE channel connector it must be set as the
master device.