Emergency Management Port Console C-5
EMP Access Modes (Server not Configured for Console Redirect)
Mode Server is powered off During POST After OS boots
Disabled Redirect window appears, but is
blank
Redirect window
appears, but is blank
Redirect window
appears, but is
blank
Pre-boot EMP commands available EMP commands
available
Redirect window
appears, but is
blank
Always Active EMP commands available E MP commands
available
EMP commands
available
EMP Requirements and Configurations
This section outlines the requirements and configurations necessary for using the EMP.
Operating Systems:
! Windows 95

16 MB of RAM, 32 MB recommended

20 MB disk space

! Windows NT

Windows NT 4.0 or later

24 MB of RAM, 32 MB recommended

20 MB disk space

Client Configuration: The EMP will support all COM ports on the client system,
along with any Windows NT/95 compatible modem.
Server Configuration: The EMP requires the server's COM 2 port to be connected to
an external modem or directly connected to a serial cable.
Direct Connect Configuration: A null modem serial cable is needed. Connect one end
of the cable into the COM 2 port of server and the other into a port on the client
machine.
Modem Configuration: On the client, the EMP uses the Windows Application
Program Interface (API) to determine if a modem is connected and available. The EMP
does not configure the modem; it should be preconfigured through Windows.
For modem support, the server must use a Hayes compatible 14400 bps modem. The
modem must be on the NT Hardware Compatibility List provided by Microsoft. The
server modem must be set in auto-answer mode for the EMP to be able to connect to it.