Connecting Your PC Or Macintosh Computer

Connecting your PC or Macintosh computer to your MultiSync MT1000 LCD Projector will enable you to project your computer's screen image for an impressive presenta- tion. All of these following display standards are supported:

VGA 6402480 for graphics

VGA 6402400 for graphics

 

 

VGA 6402350 for graphics

VGA 7202400 for text

 

 

VGA 7202350 for text

SVGA 8002600

 

 

XGA 10242768

Macintosh at 10242768

 

 

Macintosh at 6402480

Macintosh at 8322624

 

 

To connect to a PC, Macintosh or computer equipped with an XGA/SVGA/VGA adapter or compatible graphics adapter, simply:

1.Turn off the power to your LCD projector and computer.

2.If your PC does not support XGA/SVGA/VGA you will need to install an XGA/ SVGA/VGA graphics board. Consult your computer's owner's manual for your XGA/SVGA/VGA configuration. If you need to install a new board, see the manual that comes with your new graphics board for installation instructions.

37

3.Use the MultiCable that's supplied to connect your PC or Macintosh computer to the LCD projector. For a PC, use the smaller 15-pin connector on the cable to connect to your computer's video port; use the larger 15-pin connector on the cable to connect to the projector's RGB 1 input. For Macintosh, use the larger 15-pin connector on the cable to connect to your computer's video port; use the smaller 15-pin connector on the cable to connect to the projector's RGB 2 input. (You can also use your own video cable if you wish. For a PC cable, use the smaller 15-pin connector RGB 2 on the projector. For a Macintosh cable, use the larger 15-pin connector RGB 1 on the projector.)

4.Turn on the LCD projector and the computer.

5.If the projector goes blank after a period of inactivity, it may be caused by a screen saver installed on the computer you've connected to the projector.

NOTE: Refer to your computer's owner's manual for more information about your computer's video output requirements and any special identification or configuring your projector's image and monitor may require.

20

INSTALLATION

38