I M P O R T A N T I N F O R M A T I O N
Precautions
Please read this manual carefully before using your NEC MultiSync MT600 LCD Projector and keep the manual handy for future reference.
Your serial number is located on the side of your MultiSync MT600, below the cooling fan vent.Record it here:
____________________________________________________________
CAUTION
RISK OF ELECTRIC SHOCKDO NOT OPEN
CAUTION
TO PREVENT SHOCK, DO NOT OPEN THE CABI- NET. NO
This symbol warns the user that uninsulated voltage within the unit may be sufficient to cause electrical shock. Therefore, it is dangerous to make any kind of contact with any part inside of the unit.
This symbol alerts the user that important information concerning the operation and maintenance of this unit has been provided. The information should be read carefully to avoid problems.
1
Cable Connection
Communication Protocol
Baud rate: | 9600 bps |
Data length: | 8 bits |
Parity: | no parity |
Stop bit: | one bit |
X on/off: | none |
Communications |
|
procedure: | half duplex |
If the CPU of the LCD projector has received the data correctly, it returns an ACK(C5H). If the received data is not correct, the CPU returns a NAK(CAH), then the following status:
Receiving success: | C5 |
Receiving failure: | CA Err |
Err 01: | Command not supported |
Err 02: | Checksum error |
Err 03: | Command not acceptable(Busy) |
Err 04: | Parameter error |
NOTE: If failing in
CA Err 1
Err 1 8X (Apply the corresponding bit.)
Bit 0: Filter cover is not attached correctly
Bit 1: Lam1p house cover is not not attached correctly
Bit 2: Overheated
Bit 3: Lamp lighting failure
PC Control Connector | To RxD of PC | |||
|
|
|
| © |
| 8 | 7 | 6 |
|
|
|
|
| |
5 |
| 4 |
| 3 |
|
| 2 | 1 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To GND of PC |
|
| To TxD of PC | ||||
ß |
|
|
|
|
|
| © |
|
|
|
|
|
| ||
SPECIFICATIONS 62