Setup
1. Determine the installation location
CAUTION: Installing your LCD display must be done by a qualified technician. Contact your dealer for more information.
CAUTION: MOVING OR INSTALLING THE LCD MONITOR MUST BE DONE BY TWO OR MORE PEOPLE. Failure to follow this caution may result in injury if the LCD monitor falls.
CAUTION: Do not mount or operate the display upside down, face up, or face down.
CAUTION: This LCD has a temperature sensor and cooling fan. If the LCD becomes overheated while the cooling fan is running, a “Caution” warning will appear. If the “Caution” warning appears, discontinue use and allow the unit to cool.
If the LCD is used in an enclosed area or if the LCD panel is covered with a protective screen, please check the inside temperature of the monitor by using the “HEAT STATUS” control in the OSD (see page 24).
IMPORTANT: Lay the protective sheet, which was wrapped around the LCD monitor when it was packaged, beneath the LCD monitor so as not to scratch the panel.
2. Install the remote control batteries
The remote control is powered by two 1.5V AA batteries. To install or replace batteries:
A.Press and slide to open the cover.
B.Align the batteries according to the (+) and
C.Replace the cover.
CAUTION: Incorrect usage of batteries can result in leaks or bursting.
NEC recommends the following battery use:
•Place “AA” size batteries matching the (+) and
•Do not mix battery brands.
•Do not combine new and old batteries. This can shorten battery life or cause liquid leakage of batteries.
•Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment.
•Do not touch exposed battery acid, it may injure skin.
NOTE: If you do not intend to use the Remote Control for a long period of time, remove the batteries.
3. Connect external equipment (See pages 14 and 15)
•To protect the external equipment; turn off the main power before making connections.
•Refer to your equipment user manual for further information.
NOTE: Do not connect/disconnect cables when turning on the monitor or other external equipment as this may result in a loss of the monitor image.
4. Connect the supplied power cord
•The equipment should be installed close to an easily accessible power outlet.
•Please fasten power cord to the LCD monitor by attaching the screw and clamp.
•Fully insert the prongs into the power outlet socket. A loose connection may cause image degradation.
NOTE: Please refer to the “Safety Precautions and Maintenance” section of this manual for proper selection of AC power cord.
Screw
Clamp
