NEC NC1600C user manual LAN port LAN-A, LAN-B RJ-45, PC card slot, Appendix

Models: NC1600C

1 57
Download 57 pages 40.83 Kb
Page 50
Image 50
6-7-3. LAN port (LAN-A, LAN-B) (RJ-45)

6. Appendix

6-7-2. Remote control input connector (REMOTE IN) (Stereo mini)

Connected with the projector’s remote control the accessory remote cable.

When the remote cable is connected to this connector, the remote cable connector operates with the following functions.

DC power supply unit for remote control

Remote signal unit

GND unit

The DC voltage supplied from the projector to the remote control is approximately +4.0 V.

NOTE

TIP

The remote control cable is connected first to the remote control, then to the projector head.

The leading end of the remote control cable is the power supply unit, so be careful not to touch the other end of the remote cable to the projector head or other devices while only the remote control cable is connected to the projector.

Even if the remote cable power supply unit and GND unit (such as the projector head) should short, the protective function inside the projector will activate to prevent the shorted cable from damaging the projector.

6-7-3. LAN port (LAN-A, LAN-B) (RJ-45)

Use Ethernet 10Base-T/100Base-TX UTP (Unshielded Twist Pair cable) to connect with a video server or a PC. A switching hub exists inside, so there are no functional differences of either the LAN-A or LAN-B ports.

Internal Configuration Diagram of LAN Port

• Video Server

• PC

LAN-A

LAN-B

• Video Server

• PC

Projector NC1600C

Cinema

LAN-CInternal Configuration Diagram of LAN Port Control

Block

Ethernet

Switching

Hub

 

 

 

System

LAN-D

 

 

 

Control

 

 

 

 

 

 

Block

6-7-4. PC card slot

Set a wireless LAN card to control the projector from a PC using wireless LAN. When you use wireless LAN, pay attention to the following points:

Connection cannot be established with an NIC (Network Interface Card) of the same network group.

Use the wireless LAN in ad hoc mode.

*The cards in the same network group have the same AND value for the IP address and the subnet mask.

50

Page 50
Image 50
NEC NC1600C user manual LAN port LAN-A, LAN-B RJ-45, PC card slot, Appendix, Internal Configuration Diagram of LAN Port