NEC NP1150, NP2150 user manual  Turning on the Projector, Remove the lens cap

3. Projecting an Image (Basic Operation)

This section describes how to turn on the projector and to project a picture onto the screen.

Turning on the Projector

NOTE:

•The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the remote control).

•When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off () po- sition. Failure to do so may cause damage to the projector.

•The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a key- word. (→ page 44)

1. Remove the lens cap.

•Do not try to remove the lens cap by pulling on the string. Doing so can cause damage.

2.To turn on the main power to the projector, press the Main Power switch to the on position ( I ).

•The projector will go into standby mode. When in stand- by mode, the POWER indicator will light orange and the STATUS indicator will light green.

USB LAMP

STATUS

POWER

3.After making sure that the projector is in standby mode, press the POWER (ON/STAND BY) or POWER (ON) button for a minimum of 2 seconds when the STATUS indicator goes off and the POWER indicator starts blinking.

When the POWER indicator turns a steady green, and the projector is ready to use.

		POWER			POWER
		OFF			ON
			COMPUTER
		VIDEO	1	2	VIEWER
			COMPONENT
		S-VIDEO		3	NETWORK
		USB
		LAMP		M ENU
		STATUS
3D.REFORM AUTO.ADJUST SOURCE	ON/STAND.By	POWER

SELECT

E	IT
NT
ER	EX

•After you turn on your projector, ensure that the comput- er or video source is turned on and that your lens cap is removed.

Standby	Blinking
LAMP	LAMP
STATUS	STATUS
POWER	POWER

	ON/STAND BY
Steady green /	Blinking green
orange light	light

Power On

LAMP

STATUS

POWER

Steady green

light

Press this button for a minimum of 2 seconds.

(→ page 125)

NOTE: When no signal is available, a blue, black or logo screen is displayed.

22