NEC NP1150, NP2150 user manual  Part Names of the Projector, Front/Top, Rear

1. Introduction

Part Names of the Projector

Front/Top

Lens Shift Dial (Right / Left,Up / Down)

(→ page 26)

Focus Ring (→ page 27)

Remote Sensor (→ page 10)

LENS RELEASE Button

(→ page 123)

Lens

Zoom Lever (→ page 27)

Lens Cap

Controls

(→ page 7)

CT SELE

Ventilation (inlet) / Filter (→ page 116)

Built-in Security Slot ( )*

Ventilation (inlet) / Filter (→ page 116)

Adjustable Tilt Foot Lever (→ page 28)

Adjustable Tilt Foot (→ page 28)

*This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kens- ington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.

Rear

Stereo Speaker (5W x 2)

USB Wireless LAN unit The model without the USB wireless LAN unit has a dummy cover here.

Terminal Panel

(→ page 8)

SELECT
3D RE
FORM	AUTO
	ADJUST

SOURCE

ON/ST

AND

BY

Lamp Cover (→ page 118)

Remote Sensor (→ page 10)

Ventilation (outlet)

Heated air is exhausted from here.

Main Power Switch

When you plug the supplied power cable into an active wall outlet and turn on the Main Power switch, the POW- ER indicator turns orange and the projector is in standby mode.

(→ page 22)

AC Input

Connect the supplied power cable’s three-pin plug here, and plug the other end into an active wall outlet.

(→ page 21)

NOTE:

The USB Wireless LAN Unit emits weak radio waves when the projector is in standby* mode or turned on.

If you use the projector with the USB Wireless LAN Unit in the area where the use of wireless LAN equipment is prohibited, re- move the USB Wireless LAN Unit from the projector. (→ page 139)

*To stop emitting radio waves from the USB Wireless LAN Unit during standby mode, select [POWER-SAVING] from [STANDBY MODE].