Overview

This document contains step-by-steps disassembly instructions for the VERSA M350/P550 chassis. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Furthermore, the screws that are removed are shown next to the image of the parts themselves.

NEC reserves the right to make changes to the VERSA M350/P550 chassis without notice.

Technician Notes

Only technicians authorized by NEC Personal Products LTD. should attempt to repair this equipment. All troubleshooting and repair procedures are detailed to allow only subassembly/module level repair. Because of the complexity of the individual boards and subassemblies, no one should attempt to make repairs at the component level or to make modifications to any printed wiring board. Improper repairs can create a safety hazard. Any indication of component replacement or printed wiring board modifications may void any warranty or exchange allowances.

Disassembly Instructions

When disassembling the system unit, follow these general rules:

„Do not disassemble the system into parts that are smaller than those specified in the instructions.

„Label all removed connectors. Note where the connector goes and in what position it was installed.

„Turn off the power and disconnect all power and all options.

Reassembly Instructions

Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws are returned to their proper positions. Check that no tools or any loose parts have been left inside the chassis. Check that everything are properly installed and tightened.

Required Tools

All disassembly procedures can be perform using the following tools:

„PH 0x60 Philips screwdriver

„PH 0x40 Philips screwdriver

„SW5.0 Spacer screwdriver

„Flat screwdriver

„Small tweezers

„Pin

NEC VERSA M350/P550 Disassembly Manual

Page 3