Installation, Attach eyebolts M12, Mounting

14-15 mm

Installation

English

This device cannot be used or installed without the Tabletop Stand or other mounting accessory for support. For proper installation it is strongly recommended to use a trained, NEC authorized service person. Failure to follow NEC standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding the warranty.

In order to aid in mounting or carrying, a lifting device must be used in conjunction with the attachable eyebolts (M12). Do not attempt to mount or carry the display using your own strength as the display may fall and cause personal injury.

Attach eyebolts (M12)

This model is equipped with attachable eyebolts (M12) to aid in mounting.

• Place the washer over the threads of the eyebolt.

• Screw the eyebolts (M12) into eyebolt holes as shown in

the picture.

• Be sure eyebolts (M12) are secure.

• In order to move the monitor into position, use a lifting

device attached to the eyebolts (M12).

Mounting

DO NOT mount the monitor yourself. Please ask dealer. For proper installation it is strongly recommended to use a trained, qualified technician. Please inspect the location where the unit is to be mounted. Mounting on wall or ceiling is the customer’s responsibility. Not all walls or ceilings are capable of supporting the weight of the unit. Product warranty does not cover damage caused by improper installation, remodelling, or natural disasters. Failure to comply with these recommendations could result in voiding the warranty.

DO NOT block ventilated openings with mounting accessories or other accessories.

For NEC Qualified Personnel:

To ensure safe installation, use two or more brackets to mount the unit. Mount the unit to at least two points on the installation location.

Please note the following when mounting on wall or ceiling

•When using mounting accessories other than those that are NEC approved, they must comply with the VESA- compatible (FDMlv1) mounting method.

DO NOT mount the monitor using only the eyebolts (M12).

Use an approved mounting accessory.

• NEC strongly recommends

using size M8 screws

(14-15 mm + thickness of

bracket and washer in length).

UnitMounting Bracket

Washer

Landscape

Washer for eyebolt (M12)

Eyebolt Hole

Eyebolt (M12)

If using screws longer than

14-15 mm, check the depth

of the hole. (Recommended

Fasten Force:

1125 - 1375 N•cm)

NEC recommends mounting

interfaces that comply with

UL1678 standard in North

America.

Screw

Thickness of bracket and washer

Screw length should equal depth of hole (14-15 mm) + the thickness of mounting bracket and washer.

Portrait

•Prior to mounting, inspect the installation location to insure that it is strong enough to support the weight of the unit so that the unit will be safe from harm.

•Refer to the instructions included with the mounting equipment for detailed information.