Manuals / Brands / Computer Equipment / Computer Hardware / NEC / Computer Equipment / Computer Hardware

NEC uPD780318 Subseries, uPD780328 Subseries, uPD780338 Subseries - page 27

1 47

Download 47 pages, 478.66 Kb

CHAPTER 3 INSTALLATION

User’s Manual U16214EJ1V0UM 27

The above steps configure the following circuit and enable supply of the clock from the mounted resonator

to the emulation device.

(3) When using external clock

No hardware settings are required for this situation.

When starting the integrated debugger (ID78K0-NS), open the configuration dialog box and select “External” in

the area (Clock) for selecting the CPU clock source (this selects the user clock).

VHC157

IE-78K0-NS or IE-78K0-NS-A side

(Emulation device)

Crystal oscillator

HSK120

Contents

Main Users Manual IE-780338-NS-EM1 Page Page Regional Information Device availability Ordering information Product release schedule Availability of related technical literature INTRODUCTION Page Page LIST OF FIGURES Page CHAPTER 1 GENERAL CHAPTER 1 GENERAL 1.1 System Configuration Page CHAPTER 1 GENERAL 1.2 Hardware Configuration Figure 1-3. Basic Hardware Configuration (Using IE-78K0-NS-A) 1.3 Basic Specifications Page CHAPTER 2 PART NAMES 2.1 Parts of Main Unit Figure 2-1. IE-780338-NS-EM1 Part Names Page 3.1 Connection Page 3.2 Clock Settings Page Page Page Page Page Page Page Page CHAPTER 3 INSTALLATION Remark The sections enclosed in broken lines indicate parts that are attached to the parts board. Circuit diagram Page Page Page CHAPTER 3 INSTALLATION 3.3 Mask Option Setting F Connection Pins Part Used Parts Board at Shipment 1-16 Capacitor C1 0.47 F 3-14 Resistor R2 2 M 4-13 Resistor R1 1 M 6-11 Capacitor C2 0.47 F 7-10 Capacitor C3 0.47 3.4 External Trigger 3.5 Jumper Settings on IE-78K0-NS 3.6 Jumper Settings on IE-78K0-NS-A 3.7 Low-Voltage Emulation Settings CHAPTER 4 DIFFERENCES BETWEEN TARGET DEVICES AND TARGET INTERFACE CIRCUITS CHAPTER 4 DIFFERENCES BETWEEN TARGET DEVICES AND TARGET INTERF ACE CIRCUITS Figure 4-1. Equivalent Circuit of Emulation Circuit 1 Figure 4-2. Equivalent Circuit of Emulation Circuit 2 CHAPTER 4 DIFFERENCES BETWEEN TARGET DEVICES AND TARGET INTERF ACE CIRCUITS Figure 4-3. Equivalent Circuit of Emulation Circuit 3 CHAPTER 5 RESTRICTIONS AND CAUTIONS ON USE APPENDIX A EMULATION PROBE PIN ASSIGNMENT TABLE Table A-1. SWEX-120SE-1 Pin Assignments (1/2) Table A-1. SWEX-120SE-1 Pin Assignments (2/2) APPENDIX B CAUTIONS ON DESIGNING TARGET SYSTEM APPENDIX B CAUTIONS ON DESIGNING TARGET SYSTEM Figure B-2. Connection Conditions of Target System Page Page Facsimile Message Thank you for your kind support. From: