![PROJECTING AN IMAGE (BASIC OPERATION)](/images/new-backgrounds/209618/20961833x1.webp)
PROJECTING AN IMAGE (BASIC OPERATION)
This section describes how to turn on the projector and to project a 2. Press the ENTER button to execute the selection. picture onto the screen.
Turning on the Projector
NOTE:
•The projector has two power switches: main power switch and POWER (ON/ STAND BY) button (POWER ON and OFF on the remote control).
•When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off (O) position. Failure to do so may cause damage to the projector.
To turn on the main power to the projector, press the Main Power switch to the on position ( I ).
Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap is removed.
Only after you press the POWER (ON/STAND BY) button on the pro- jector cabinet or POWER ON button on the remote control for a mini- mum of 2 seconds will the power indicator turn to green and the projec- tor become ready to use.
After this has been done, you can proceed to the menu operation.
If you want, you can select the menu language later. See "Language" on page
NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.
When the Lamp mode is set to Eco, the Lamp indicator will light green. If one of the following things happens, the projector will not turn on.
*If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal components to cool down.
*When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
*If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and then turn on the power.
Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup screen. This screen gives you the opportunity to select one of the 21 menu languages. To select a menu language, follow these steps:
1.Use the SELECT G or H button to select one of the 21 languages for the menu.