NEC VT460K, VT660K Troubleshooting, E-32, Power Indicator, Projector Condition, Status Indicator

TROUBLESHOOTING

This section helps you resolve problems you may encounter while setting up or using the projector.

Power Indicator

	Indicator Condition		Projector Condition	Note
	Off		The main power is off.	–
Blinking light	Green	0.5 sec On,	The projector is getting ready	Wait for a moment.
		0.5 sec Off	to turn on.
	Orange	0.5 sec On,	The projector is cooling down.	Wait for a moment.
		0.5 sec Off
Steady light	Green		The projector is turned on.	–
	Orange		The projector is in Standby.	–
Status Indicator
	Indicator Condition		Projector Condition	Note
	Off		Normal	–
Blinking light	Red	1 cycle (0.5 sec On,	Lamp cover error or lamp	Replace the lamp cover or
		2.5 sec Off)	housing error	lamp housing correctly.
		2 cycle (0.5 sec On,	Temperature error	The projector is overheated.
		0.5 sec Off)		Move the projector to a cooler
				location.
		4 cycle (0.5 sec On,	Fan error	Fans will not work correctly.
		0.5 sec Off)
		6 cycle (0.5 sec On,	Lamp error	Lamp fails to light. Wait a full
		0.5 sec Off)		minute and then turn on again.
	Green		Re-firing the lamp	The projector is re-firing.
Steady light	Orange		Control Panel key locked	You have pressed control
				panel key when Control Panel
				Key Lock is enabled.
Lamp Indicator
	Indicator Condition		Projector Condition	Note
	Off		Normal	–
Blinking light	Red		Lamp has reached its end of	Replace the lamp.
			life. Lamp replacement mes-
			sage will be displayed.
Steady light	Red		Lamp has been used beyond	Replace the lamp.
			its limit. The projector will not
			turn on until the lamp is re-
			placed.
	Green		Lamp mode is set to Eco mode.	–

E-32