3. Projecting an Image (Basic Operation)
5.Repeat steps 3 and 4 to correct keystone distortion.
6.After completing Keystone correction, press the ENTER button. The Keystone screen will disappear.
•To perform Keystone correction again, press the 3D REFORM button to display the Keystone screen and repeat above steps 1 to 6.
NOTE:
•Turning on the projector will reset the previous correction setting values if the projection angle is changed from the last use. If the projection angle is the same as in the last use, the previous correction setting values are retained in the memory.
To use the previous correction setting values after changing projection angle, select "Manual" in "Keystone" from the menu. See page 87.
To return the 3D Reform correction setting values to the factory preset, press and hold the 3D REFORM button for a minimum of 2 seconds.
•Each time the 3D REFORM button is pressed, the item will change as follows: Keystone → Cornerstone → None → Keystone → ...
For information on “Cornerstone”, see “Correcting Horizontal and Vertical Keystone Distortion (Cornerstone) on page 44.
•You can zoom in or out, while keeping an image that was corrected using "Keystone", without again having to make those adjustments.
36
