NEC WT610E Input Panel , , Control Codes l Codes

NEC Display Solutions of America, Inc.
WT610E Installation Guide
Desktop and Ceiling Mount v2.4
www.necdisplay.com WT610E Page 9 of 9
Input Panel
MONITOR OUT
COMPUTER
COMPUTER IN
Control Codes l Codes
Function Code Data
POWER ON 02H 00H 00H 00H 00H 02H
POWER OFF 02H 01H 00H 00H 00H 03H
INPUT SELEC T RGB 02H 03H 00H 00H 02H 01H 01H 09H
INPUT SELEC T DVI (ANALOG) 02H 03H 00H 00H 02H 01H 02H 0AH
INPUT SELEC T DVI (DIGITAL) 02H 03H 00H 00H 02H 01H 1AH 22H
INPUT SELEC T VIDEO 02H 03H 00H 00H 02H 01H 06H 0EH
INPUT SELEC T S-VIDEO 02H 03H 00H 00H 02H 01H 0BH 13H
INPUT SELEC T VIEWER 02H 03H 00H 00H 02H 01H 1FH 27H
PICTURE MUTE ON 02H 10H 00H 00H 00H 12H
PICTURE MUTE OFF 02H 11H 00H 00H 00H 13H
SOUND MUTE ON 02H 12H 00H 00H 00H 14H
SOUND MUTE OFF 02H 13H 00H 00H 00H 15H
ON SCREEN MUTE ON 02H 14H 00H 00H 00H 16H
ON SCREEN MUTE OFF 02H 15H 00H 00H 00H 17H
Note: Contact your NEC rep for codes not listed.
Cable Connection
Communication Protocol: PC Control Connector (DIN-8P)
Baud Rate: 38400 bps
To RxD of PC
12
345
678
To TxD of PC
To GND of PC
Data Length: 8 bits
Parity: No Parity
Stop Bit: One bit
X on/off: None
Communications: Full duplex
NOTE 1: It is recommended to set the projector to “Idle Mode” in the Setup menu for best Power ON response.
NOTE 2: Pins 2, 3, 5, 6 and 8 are used inside the projector.
NOTE 3: For long cable runs it is recommended to set communication speed in the Setup menu to 9600 bps.