Net Optics PA-CU-AR, PAD-CU-AR manual Cabling Guidelines, Connecting to the Network

10/100 Port Aggregator Tap

Cabling Guidelines

Use straight-through cable to connect the Tap Ports to a Router or NIC. .Use cross-over cable to connect the Tap Ports to Switches and Hubs. .The Tap Ports Transmit on Pins 3 & 6 and Receive on Pins 1 & 2..

Note:________________________________________________________________

You must ensure that both Network Ports A and B match speed and duplex settings on your network devices.

______________________________________________________________________

Connecting to the Network

1. . Connect Network Port A to the appropriate network device following the cabling guidelines above. .

2. .Connect Network Port B to the appropriate network device following the cabling guidelines above. .

3. . Verify that the Tap Network Ports are cabled in-line between two devices..

	A	B	1	2
®
Passive Dual	2
Port Aggregator with	1
Active Response
	10 LINK	10 LINK	10 LINK	10 LINK
www.netoptics.com	100 ACT	100 ACT	100 ACT	100 ACT

	To network switch or router
To network switch or router

Figure 7: Connecting to the Network