Appendix A Signal Connection Arrangements
RJ-45 Ethernet Port
The HS960
Depending on the type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as prescribed. 10Mbps: Use
100Mbps: Use EIA/TIA-568-100-Category 5 cable.
Figure A-1 RJ-45 Connector and Cable Pins
Note: To prevent loss of signal, make sure that the length of any
Appendix B Regulations/EMI Compliance
FCC Regulatory Statement
Part 15-Class B compliant device
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:
1This device may not cause harmful interference, and
2This device must accept any interference received, including that which may cause undesired operation.
This equipment has been test and found to comply with the limits for a computing device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1Reorient or relocate the receiving antenna.
2Increase the separation between the equipment and receiver.
3The equipment and the receiver should be connected the outlets on separate circuits.
4Consult the dealer or an experienced radio/television technician for help.
Changes or modification not expressly approved be the party responsible for compliance could void the user’s authority to operate the equipment.
YML857 Rev1 | HS960 Wireless Gateway User Guide |
www.netcomm.com.au | 117 |
