NetComm IG6000 manual #MEM0, #MEM1, #MEM2, #Mini

Industrial Modem User Guide

&F1		Restore non­error correction factory defaults
&F.		Reset modem (clear security database/Telephone numbers)
&G0	n	No guard tone generated
&G1		550 Hz guard tone generated
&G2		1800 Hz guard tone generated
&K0		Flow control disabled
&K3		RTS/CTS flow control
&K4		XON/XOFF flow control
&K5		Transparent XON/XOFF flow control
&K9	n	Failsafe flow control
&M0	n	Asynchronous mode
&N0		Abort dial character disabled
&N1	n	Abort dial character enabled
&P0		39/61 make/break ratio (USA)
&P1	n	33/67 make/break ratio (Aus/UK)
&S0		DSR signal always asserted
&S1	n	DSR signal asserted at start of handshake
&S2		DSR signal asserted at end of handshake (before CONNECT message)
&T0		Terminate current test
&T1		Local Analogue Loopback test
&T3		Local Digital Loopback test
&T4	n	Grant Remote Digital Loopback test
&T5		Deny Remote Digital Loopback test
&T6		Remote Digital Loopback test
&T7		Remote Digital Loopback with Self­test
&T8		Local Analog Loopback with Self­test
&V		View active configuration profile
&Vn		View stored profile (n=0­3)
&V8		View differences between active and default
&Wn		Save current configuration into stored profile n (n=0,1,2,3)
&Yn		Select stored profile n for Power on and &D3
&Zn=x		Store x as phone number n (x=0­9)
#A0		Prevent Remote Access
#A1		Allow remote access
#A2	n	Allow remote access with security password
#ALMn=x		Dial number/s x (x=0­9 in &Z) for remote alert n
#B0	n	In 1200bps originate mode B0=V.23, B2=V.22
#B1		In 1200bps originate mode B0=V.22, B2=V.23
#C0		V.25 calling tones disabled
#C1	n	V.25 calling tones enabled
#J0		Assume V.42 compatibility
#J1	n	Check V.42 compatibility
#K0		Disable MNP 10
#K1	n	Enable MNP 10
#K2		Enable MNP 10 for Cellular links
#MEM0		All voice features off
#MEM1	n	Voice mode after S110 rings if DTR is low
#MEM2		Voice mode after S110 rings regardless of DTR
#MINI		Erase Voice mode alarm message
#M0	n	AT command operation
#O0	n	Characters ignored if modem buffers overflow

YML391­3A 16