NetComm NP6800 - page 20

www.netcomm.com.au Rev.1 - YML655

Page 20 NP6800 - Wireless LAN Access Point

3. If the IP address and Community are correct the following window will be displayed.

The SNMP Manager will display the following menus, which can be used to configure the

Access Point.

■File menu

■Setup Menu

■Commands Menu

■Info Menu

■Traps Menu

■Network Menu

■Window Menu

■About Menu

Refer to the following sections for more information on the above menus.

Contents

Main Contents Introduction About the NetComm NP6800 - Wireless LAN Access Point NetComm NP6800 - Wireless LAN Access Point LED Descriptions Wireless LAN Basics Ad-Hoc (IBSS) Mode Infrastructure (ESS or 802.11-Station) Mode 11 Mbps Operation Signal Range Page Installation Page Driver Installation & Configuration Installing the WLAN Driver in Windows 98/ME/2000 operating system Installing the Driver in Windows XP Installing the Access Point Utility Page Configuring the Access Point Configuring the Access Point via USB IP Address Subnet Mask Community (password) WEP Page Configuring the Access Point via Ethernet Assigning a Temporary IPAddress Connecting to the Access Point using the SNMP Manager Page File Menu Setup Menu Bridge Wireless LAN Page Page Operation Mode Page Page Page Enable SNMP traps Page Info Menu Page Page Advanced Topics Network Topology IBSS BSS ESS How to Make Your Wireless Network More Secure Glossary Page Troubleshooting Windows Troubleshooting Tips Registering your NetComm Product Contact Information Trademarks and Notices Warranty Registration Form ! The following information is vital for your warranty you fill this section in! Page Product Warranty Limitations of Warranty