NETGEAR CM212 - page 7

Configure the Computer to Work with

the Modem

Next, you configure the computer to interact with the modem.

USB Connection

Note: The modem must be connected to the Coaxial Cable and established link

(Cable and Status Lights are solid Green) before your PC will recognize the modem.

For the USB connection, you need to install USB drivers on your Windows computer.

1. If the computer was turned off, turn it on now.

2. Insert the CM212 GearBox CD in the computer’s CD-ROM drive.

3. Once the following dialog box appears click Next.

Contents

Main Introduction CM212 Broadband Cable Modem Installation Overview Whats in the Box Prepare for Installation USB Connection Install the Cable Modem USB Connection Page Page Page Page Page Page Macintosh Operating System Linuxor UNIXOperating System Page Sharing Your Cable Internet with Multiple Computers Troubleshooting No lights are lit on the modem The Cable light doesnt light up The USB or Ethernet light doesnt light up I cannot get onto the Internet with a computer Resetting TCP/IP Properties (Windows) Glossary of Terms Cable Modem System Requirements Modem Specifications Environmental Specifications Voluntary Control Council for Interference (VCCI) Statement EN 55 022 Declaration of Conformance Federal Communications Commission (FCC) Compliance Notice:Radio Frequency Notice Canadian Department of Communications Radio Interference Regulations Rglement sur le brouillage radiolectrique du ministre des Communications Technical Support *M1-CM212NA-0*