Install the WiFi Extender

Place the extender, apply power, and connect it to your WiFi network.

Place the Extender and Apply Power

1.Place your extender in the same room as your WiFi router.

Note: Proximity to the WiFi router is required only during the initial setup process.

2.Plug the extender into an electrical outlet.

The Power LED lights green. If the Power LED does not light, press the Power button.

3.Make sure that the switch on the extender is set to Extender.

To extend the range of your WiFi network, you must connect the extender to your existing WiFi network. You can do this in one of two ways:

•Connect with WPS. For more information, see Connect with WPS on page 6.

•Connect with genie Smart Setup. For more information, see Connect with NETGEAR genie Smart Setup on page 8.