NETGEAR FA310TX manual Connect the Network Cables

Connect the Network Cables

Using the appropriate UTP cable, connect any port on a network hub to the port on the network card.

Note: One of the ports on NETGEAR hubs is switchable between Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push button. If you are using this switchable port on a NETGEAR hub to connect to a PC or the network card, make sure the Normal/Uplink push button is set to Normal.

PC with network card installed

Power adapter	PC with network
	card installed

Printer (optional)

Hub

RJ-45	RJ-45
connector
	connector

Category 5 10/100 Mbps UTP cables*

*Use the cables provided or any Category 5 UTP cable. Maximum length = 100 meters (300 feet)

7995FB

Model FA310TX Network Card Installation Guide