Verify Installation
3.Set the FDX or AUTO toggle switches on the rear panel for the selected duplex mode.
A hub and repeater use a common collision domain for all communications and cannot support
When connecting to a PC, a server, or another switch, the duplex setting for the port must be the same as the duplex setting on the PC, server, or other switch.
To set the 10/100 Mbps ports for the selected duplex mode:
•Move the toggle switch into the down position (to AUTO) for
•Move the toggle switch into the up position (to FDX) for
4.Connect one end of the DC power adapter cable to the power outlet on the rear panel of the switch and the other end of the power adapter cable to the wall outlet.
When power has been applied to the switch:
•The green Pwr (Power) LED on the front panel is on.
•The green Link LED on each connected port is on.
When the switch is connected and operating, refer to the table in “LEDs” for information about the LEDs and their activity.
Model FS102, Model FS104, Model FS108 Fast Ethernt Switch Installation Guide