NETGEAR FS700TS Panel Layout Guide

Hardware Installation Guide for the Prosafe Stackable Smart Switch FS700TS Series

Introduction 2-7

v1.0, December 2005

If any item is missing or damaged, contact the place of purchase immediately.

Panel Layout Guide

FS728TS Front Panel

The NETGEAR FS728TS Smart Switch is a 24-Port 10/100M Stackable Smart Switch with 4

Gigabit Ports. Each RJ45 port automatically senses the line speed and negotiates duplex mode

operation with the link partner.

The following figure shows the NETGEAR FS728TS Smart Switch front panel:

1. (1a-1m) LEDs for the top row of 10/100M ports (odd-numbered ports 1-23)

2. (2a-2m) LEDs for the bottom row of 10/100M ports (even-numbered ports 2-24)

3. LED for the top-most SFP port (port 25F)

4. LED for the bottom-most SFP port (port 26F)

5. Reset button

6. Stack ID LED

7. Power LED

8. Stack Master LED

9. 24 RJ-45 connectors for 10BASE-T and 100BASE-TX (ports 1-24)

10. 2 Gigabit Interface Converter SFP slots for SFP modules (ports 25F and 26F)

11. 4 RJ-45 connectors for 10BASE-T, 100BASE-TX and 1000BASE-T (ports 25T, 26T, 27, and

28)

12. Factory Defaults button

Figure 2-3

Contents

Main Page Page Product and Publication Details Contents Hardware Installation Guide for the Stacking Smart Switch FS700TS Series Page Chapter 1 About This Manual Audience, Scope, Conventions, and Formats How to Use This Manual How to Print this Manual Page Page Chapter 2 Introduction Overview Page Stacking Features Other Features Application ExampleDesktop Switching Package Contents Panel Layout Guide FS728TS Front Panel FS752TS Front Panel FS752TPS Front Panel 2-10 Introduction v1.0, December 2005 LED Designations Port LEDs The following table describes the port LED designations. Table 1. Port LEDs Non-POE Device Table 2-1. PORT LEDs on Non-PoE Devices Introduction 2-11 Table 2-2. Port LEDS on PoE Devices Front Panel Buttons Device Hardware Interfaces Page Chapter 3 Installation Step 1: Preparing the Site Step 2: Installing the Switch Installing the Switch on a Flat Surface Installing the Switch in a Rack Step 3: Checking the Installation Step 4: Connecting Devices to the Switch Step 5: Installing an SFP GBIC Module Step 6: Installing Device as Stand-alone or Stack Master Page Step 7: Applying AC Power Step 8: Switch Management through a Web Browser or the PC Utility for Initial Configuration Page Troubleshooting 4-1 Chapter 4 Troubleshooting Troubleshooting Chart The following table lists symptoms, causes, and solutions of possible problems. Table 4-1. Troubleshooting Chart Additional Troubleshooting Suggestions Network Adapter Cards Configuration Switch Integrity Page Page Technical Specifications A-1 Appendix A Technical Specifications A-2 Technical Specifications Page Page Appendix B Related Documents