NETGEAR FS700TS Step 3: Checking the Installation

Hardware Installation Guide for the Prosafe Stackable Smart Switch FS700TS Series

Installation 3-3

v1.0, December 2005

5. Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.

Step 3: Checking the Installation

Before applying power check the following:

1. Inspect the equipment thoroughly.

2. Verify that all cables are installed correctly.

3. Check cable routing to make sure cables are not damaged or creating a safety hazard.

4. Ensure all equipment is mounted properly and securely.

Figure 3-1

Contents

Main Page Page Product and Publication Details Contents Hardware Installation Guide for the Stacking Smart Switch FS700TS Series Page Chapter 1 About This Manual Audience, Scope, Conventions, and Formats How to Use This Manual How to Print this Manual Page Page Chapter 2 Introduction Overview Page Stacking Features Other Features Application ExampleDesktop Switching Package Contents Panel Layout Guide FS728TS Front Panel FS752TS Front Panel FS752TPS Front Panel 2-10 Introduction v1.0, December 2005 LED Designations Port LEDs The following table describes the port LED designations. Table 1. Port LEDs Non-POE Device Table 2-1. PORT LEDs on Non-PoE Devices Introduction 2-11 Table 2-2. Port LEDS on PoE Devices Front Panel Buttons Device Hardware Interfaces Page Chapter 3 Installation Step 1: Preparing the Site Step 2: Installing the Switch Installing the Switch on a Flat Surface Installing the Switch in a Rack Step 3: Checking the Installation Step 4: Connecting Devices to the Switch Step 5: Installing an SFP GBIC Module Step 6: Installing Device as Stand-alone or Stack Master Page Step 7: Applying AC Power Step 8: Switch Management through a Web Browser or the PC Utility for Initial Configuration Page Troubleshooting 4-1 Chapter 4 Troubleshooting Troubleshooting Chart The following table lists symptoms, causes, and solutions of possible problems. Table 4-1. Troubleshooting Chart Additional Troubleshooting Suggestions Network Adapter Cards Configuration Switch Integrity Page Page Technical Specifications A-1 Appendix A Technical Specifications A-2 Technical Specifications Page Page Appendix B Related Documents