NETGEAR FSM726 Reset Button

Page 12 of 12

In addition to using the console port, you can manage the switch using a Web browser or a Simple Network

Management Protocol (SNMP) management program.

Note: You must use the console port for the initial management configuration.

For more information about console-port connections, see “Connecting to the Console Port” in Chapter 3

Installation. For more information about managing the switch, see the User Manual located on the CD-

ROM.

Reset Button

This recessed button on the front panel once pushed will perform a hardware reset of the switch. This is

equivalent to power-cycle the switch. The reset will not change any of the switch's configuration, nor will it

save any changes to the configuration. Please do not push this button if you're in the middle of

downloading a new firmware.

Contents

Main Page 1 of 1 Page CONTENTS Figures Tables CHAPTER 1: INTRODUCTION Overview Features Page Package Contents Verify that your package contains the following: CHAPTER 2: PHYSICAL DESCRIPTION Front and Back Panels 10/100 Mbps RJ-45 Ports Gigabit Ethernet Ports (RJ-45 and GBIC module bay) LED Descriptions Console Port Reset Button CHAPTER 3: INSTALLATION Step 1: Preparing the Site Step 2: Installing the Switch Step 3: Checking the Installation Step 4: Applying AC Power Step 5: Connecting Devices to the Switch Step 6: Installing a GBIC Module Step 7: Connecting to the Console Port to Manage the Switch (initial configuration) Page Page APPENDIX A: TECHNICAL SPECIFICATIONS Page APPENDIX B: TROUBLESHOOTING Troubleshooting Chart Additional Troubleshooting Suggestions Page Page 23 of 23 APPENDIX C: Default Settings This appendix provides the default settings for the NETGEAR Model FSM726 Managed Switch.