Reference Guide for the Model RT210/RT211 ISDN Routers

3-2 Configuring the Router

Using the Commands in the Interface

When using the Quick Setup in the built-in interface, you are prompted as you move through the

screens. When using the Basic Setup in the built-in interface, you need to know the commands that

enable you to move through the screens. Table 3-1 provides the key character commands,

Table 3-2 provides a list of the task commands, and Table 3-3 provides the control character

commands.

Table 3-1. Key character commands

Keys Action
Arrow Move from parameter to parameter in any menu.
[Enter] Move from parameter to parameter in any menu.
[Tab] Move from parameter to parameter in any menu.
Space bar Select between fixed values in certain parameters.

Table 3-2. Task commands

Command Action
DEFCON Default the currently saved configuration. Enter Y to erase the saved configuration,
reboot, and load the default configuration.
REBOOT After being asked to confirm the action, use this command to reboot. Unsaved
configuration changes are lost and the system resets. The stored configuration is loaded.
DCONFIG List the configuration. The screen pauses before listing the configuration. If a record is
required of the configuration, the attached terminal should have the capture mode
activated. Press the space bar to start listing the configuration. Upon completion,
terminate the file capture and press the space bar to return to the menu system.
LCONFIG Load an existing configuration file into the router. When prompted, send the file to the unit
as an ASCII file. When the configuration file has been loaded into memory, the unit
automatically reboots itself with the new configuration.
VER View the current operating version of the software.
NGRRT210.BK Page 2 Friday, October 17, 1997 2:37 PM