NETGEAR SC101 manual Unique Name

PARTITION	Unique network identifier for each partition. (This is the
	same value that appears in the "ut getpart" command as
	UNIQUE NAME.)
LABEL	What each partition is named. In this example, the first
	partition is "test20gb"
IP ADDR	the IP address of each partition on your network.
SIZE(M)	size in MB of each partition. The first partition is
	20,480 MB, that is, 20 GB.
MicroSan	MicroSan found within subnet is either
	∙ "1 MicroSan found within subnet" = 1 physical hard
	disk, or 2 physical hard disks which are mirrored.
	∙ "2 MicroSan found within subnet" = 2 physical hard
	disks, which are not mirrored

The same LABEL and PARTITION appear on the top and bottom half. This SC101 is mirrored. If it was not mirrored, then the information on the top and bottom would not match, but would correspond to how you partitioned each SC101 disk, separately.

4.Type ut. The list of CLI commands for the SC101 appears.

5.All commands start with "ut", e.g., "ut listall". Most commands must be followed by the rootAddr and other information such as the partitionAddr, the roottoken, or a filename.

∙rootAddr = "ROOT IP ADDR" from the "ut listall" command.

∙partitionAddr = "IP ADDR" from the "ut listall" command, in the PARTITION section.

∙roottoken = The SC101 administration password. If you have not changed it from the default, it's password.

∙filename = The filename of a file that you wish to put on the SC101.

24