NETGEAR WGE111 See “Using the NETGEAR Smart Wizard, Configuration Assistant” on page 3-9 for

User Manual for the NETGEAR WGE111 Wireless Game Adapter

I have a gaming	If using a switch or	With power on, disconnect everything from the
console, computer,	hub with an	switch or hub. Re-connect the WGE111
and the wireless	Ethernet-enabled	Wireless Game Adapter, then connect the game
game adapter	gaming console, the	console(s).
connected through a	gaming console	Finally, connect the other device(s).
switch. The	must be powered on
computer connects	before the other
to the Internet but	Ethernet-enabled
the gaming console	devices.
can't.
I can connect to an	This could be a	Check to make sure that the access point is
access point, but I	physical layer	physically connected to the Ethernet network.
cannot connect to	problem or a	Make sure that the IP addresses and the
other computers on	network
		Windows networking parameters are all
the network or the	configuration
		configured correctly.
Internet.	problem.
		Restart the cable or DSL modem, router, access
		point, and notebook PC.
I am using Ad-Hoc	This could be due	Each WGE111 Wireless Game Adapter is
mode and my two	to conflicting IP	factory-shipped with the IP address
WGE111 Wireless	addresses.	192.168.0.202. You should not use the same IP
Game Adapters		address for more than one device on your
cannot connect.		network.
		Change the IP address of one of the adapters.
		See “Using the NETGEAR Smart Wizard
		Configuration Assistant” on page 3-9 for
		information on setting the IP address.

5-4 Troubleshooting