XAV5501 Powerline AV+ 500 Adapter User Manual
Adding Adapters to Your Network
Once the first adapter is installed and connected to your router, you can easily add adapters into your network.
To add Powerline adapters:
1.Be sure the first Powerline adapter is connected to your router.
2.Plug additional Powerline adapters into power outlets near the other computers and additional peripheral devices to be included in your Powerline network.
3.Use the gray Ethernet cable from the XAV5501 package to connect from the Powerline adapter to an Ethernet port located on the other computer or peripheral device.
4.Wait for each Powerline adapter to be recognized by the Powerline network.
The Power, Ethernet, and Powerline LEDs should turn on. This could take as little as 5 seconds, or up to 80 seconds. For details about how the LEDs work, see Table 1 on page 6.
5.Test to make sure that each computer connected to a Powerline XAV5501 Adapter can access the Powerline network.
For example, be sure that you can access the |
|
Internet from a remote computer. | Figure 4. Add an adapter |
| |
One way to test this is to install the Powerline |
|
utility and use it to view all the computers |
|
connected by the Powerline AV Ethernet adapter. |
|
CAUTION:
NETGEAR recommends that you secure your Powerline network from unauthorized access. This is especially relevant in settings such as
apartment buildings. See Understanding Powerline Network Security on
page 10.
Chapter 1. Installation and Basic Configuration 9
