NETGEAR XS712T manual Apply AC Power,  To apply AC power

XS712T Smart Switch

*67;6

3RZHU

/LQN$FW0RGH 































































































)

)

)

)

)DQ

*UHHQ

/LQNDW *

<HOORZ

/LQNDW 

6WDFN

0

0DVWHU

,'

5HVHW	)DFWRU\	*UHHQ */LQN<HOORZ *
	'HIDXOWV	%OLQN $&7

Figure 8. Installing an SFP transceiver module

Step 6: Apply AC Power

The smart switch does not have an on/off switch. Power is controlled by the power cord connection.

Before connecting the power cord, select an AC outlet that is not controlled by a wall switch, which can turn off power to the switch.

To apply AC power:

1.Connect the end of the power connection cable to the power receptacle on the back of the switch.

2.Connect the AC power connection cable into a power source such as a wall socket or power strip.

When you apply power, the Power LED on the switch’s front panel lights.

If the Power LED does not light, check that the power cable is plugged in correctly and that the power source is good. If this does not resolve the problem, see Appendix A, Troubleshooting.

Step 7: Manage the Switch Using a Web Browser or the Smart Control Center Utility

The smart switch contains software for viewing, changing, and monitoring the way it works. This management software is not required for the switch to work. You can use the ports without using the management software. However, the management software enables the setup of VLAN and trunking features and also improves the efficiency of the switch, which results in the improvement of its overall performance as well as the performance of the network.

After you power up the switch for the first time, you can configure the smart switch using a web browser or a program called Smart Control Center. For more information about

20