XS712T Smart Switch | NETGEAR instruction

XS712T Smart Switch

managing the switch, see the software administration manual on the smart switch resource CD.

Note: The switch is configured with a default IP address of 192.168.0.239 and a subnet mask of 255.255.255.0.

21

Image 21

NETGEAR manual XS712T Smart Switch

Contents

XS712T Smart Switch Support TrademarksRevision History Contents Appendix C Notification of Compliance Introduction Overview Features Package Contents XS712T Smart Switch Physical Description LED Designations Front Panel and Back Panel Configuration Device Hardware Interfaces Port LEDsSystem LEDs Factory Defaults Button Reset ButtonRJ-45 Ports SFP+ Ports Applications Backbone Switching Desktop Switching Backbone switching Installation Install the Switch on a Flat Surface Install the Switch To install the switch on a flat surface Prepare the Site Connect Devices to the Switch Check the InstallationInstall the Switch in a Rack  To install the switch in a rack Install an SFP Transceiver Module  To connect devices to the switch To install an SFP transceiver  To apply AC power Apply AC Power XS712T Smart Switch Troubleshooting Additional Troubleshooting Suggestions Troubleshooting ChartConfiguration Network Adapter Cards Autonegotiation Switch Integrity Technical Specifications Management Network Protocol and Standards Compatibility Power Supply Performance SpecificationsPhysical Specifications Environmental Specifications Safety Regulatory Compliance Information Netgear Wired ProductsEurope EU Declaration of Conformity FCC Requirements for Operation in the United States XS712T Smart Switch FCC Guidelines for Human Exposure