1212
EN 1313 EN
7. Accessories* (see photos in appendix)
Elastic Suspensions
EA 2 ..........................ni ..................Cat. No . 008432
Table and Floor Stands
MF 3..........................blk ................Cat. No . 0073 21
MF 4 .........................blk ................Cat. No. 007337
MF 5 .........................gry ................Cat. No. 008489
Auditorium Hanger
MNV 87 ....................ni ..................Cat. No. 006804
Stand Mounts, Misc. Mechani cal Adapters
DS 120 .....................blk ................Ca t. No. 00734 3
SG 1 ..........................blk ................Cat. No. 008445
Foam Windscreens
WS 47 .......................blk ................Cat. No. 006826
8. Scope of delivery
Mono set Stereo set Microphone
D-01 microphone 2 D-01 microphones D-01 microphone
EA 2 elast. suspension 2 EA 2 elast. suspensions
DMI-2 interface DMI-2 interface
USB 485 converter USB 485 converter
Operating manuals Operating manuals Operating manual
Aluminium case Aluminium case Wooden case
IC 3 cable 2 IC 3 cable
RJ 45 cable RJ 45 cable
BNC cable BNC cable
USB cable USB cable
AC line cable AC line cable
9. Troubleshooting*
Problem
▶
Possible causes
▶
Solution
Microphone not
operating /
No signal
transmission
Supply voltage not activate d Check the power supply device a nd if necessar y
the associ ated s oftwa re set tings (RCS -> System ->
MicPWR).
The microphone is not connected
to an AES 42 i nput
Use an AES 42 input.
The microphone is not connected
to the correct channel
Check the signal path.
If necessary, activate the appropriate input on the
corresponding channel of the m ixing console.
The channel is muted Deactivate the mute in th e AES 42 remote con trol.
Distorted
sound /
bad signal
quality
Excessive sound pressur e of the
signal to be recorded
Take a more distant microphone position or activate
the pre-attenuation in the AES 42 remote control.
Overload due to low-frequency
interference (e.g. impact sound
or wind)
Use an appropriate windscreen (accessory). Activate
the pre-attenuation in the AES 42 remote control.
Use an appropriate popscreen (accessory). Activate
the pre-attenuation in the AES 42 remote control.
* Please see also the manual of the DMI-2 for further t rouleshoo tings.
Popscreen
PS 15 .......................blk ................Cat. No. 008472
PS 20 a ...................blk ................Cat. No. 008488
Connecting Cables
IC 3 mt ....................blk ................Cat. No. 006543
IC 4 ...........................ni ..................Cat. No. 006547
Meaning of color codes:
ni = nickel, blk = black, gry = gr ey
* Detailed descriptions and additional articles can be found
in our accessories cat alog or at: ww w.neumann .com