with the holes in the lower handlebar sections.
3.The handlebars have three height adjustments (three holes in the upper handlebars). Connect the handlebars at the height that is most comfortable for you.
4.Slide the connector bolts (from inside to outside) through the holes in the upper and lower handlebar sections on each side of the Mower. Screw on the black connector knobs, then
5.Swing the upper handlebar assembly into an upright position. The bars will line up and slide into place (Figure 8).
6.Check the length of the handlebars for comfort. If necessary, reconnect the handlebars (up or down) to a height that is best for you.
Figure 8. Align the upper and lower handlebars and hand-tighten the black connector knobs
To save space for storage, you can loosen these black
connector knobs to drop the upper handlebar assembly forward onto the Mower’s deck.
Step 6: Attach the Cable to the Handlebar Assembly
1.Run the cable through the cord clip (Figure 9) on the right lower handlebar section.
2.Align the
handlebars, and slide together. 3.
Figure 9. Cord clip on the lower right |
|
|
| |
Figure 10. The | Figure 11. | |||
handlebar | ||||
locking nut | ||||
|
NEUTON EM 5.1 Cordless Electric Mower Safety & Operating Instructions | 15 |