Disassembly Procedures
!WARNING
To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.
Moving and/or Replacing Range
1.Turn off electrical power and gas supply to the range.
2.Slide range forward from installation position.
3.Unplug power cord and disconnect gas line from unit.
4.Replace range using Installation Instructions.
NOTE: When placing range into installation position verify
Leveling Legs
•Some floors are not level.
•For proper baking, your range must be level.
•Leveling legs are located on each corner of the base of the range.
•Place a level horizontally on an oven rack and check
Anti-Tip Bracket
When ever range is moved or replaced for safety reasons this bracket must be engaged.
Anti-Tip Bracket
Leveling Leg
Maintop Removal
1.Disconnect power before servicing.
2.Remove surface burner control knobs by grasping knob and raising knob straight upward.
3.Remove screws securing infinite switch bracket to maintop.
4.Remove screws securing burner assemblies to maintop.
5.Remove screws securing maintop to chassis. Screws are located in the front left and right corners with the upper oven door open.
6.Remove screws securing ground strap to chassis.
7.Raise and remove maintop from unit.
8.Reverse procedures to reassemble.
Top Surface Valve and Spark Switch
1.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)
2.Remove spark switch(es) by pulling upward off valve.
3.Remove wires from spark switch by depressing release arm.
4.Remove bolt(s) securing surface valve(s) to manifold. Located on the bottom of manifold.
5.Reverse procedures to reassemble.
NOTE: Perform gas leak test.
Top Burner Lower Assembly
1.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)
2.Disconnect tubing from lower assembly.
3.Reverse procedures to reassemble.
NOTE: Perform gas leak test.
Top Burner
1.Disconnect power before servicing.
2.Remove screws securing burner to burner lower assembly.
3.Reverse procedures to reassemble.
Side Panel
NOTE: Removal of range from installation position is required.
1.Disconnect power before servicing.
2.Remove range from installation position, see "Move and/or Replacing Range" procedure.
3.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)
4.Remove screws securing right side panel at the top and back of panel.
5.Pull side panel outward away from rear of range, then lift upward on the side panel to release from slotted clips located in front and set aside.
6.Reverse procedures to reassemble.
Manifold and Top Burner
1.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)
NOTE: If replacing manifold only, skip step 2.
2.Loosen and disconnect fittings securing surface burner tubing to burner assembly and manifold.
3.Remove bolt(s) securing surface valve(s) to manifold.
4.Remove bolt securing
5.Disconnect tubing from manifold to the regulator.
6.Reverse procedures to reassemble.
NOTE: Perform gas leak test.
©2004 Maytag Services | 16023417 | 21 |