Disassembly Procedures
!WARNING
To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.
Oven Door Hinge
NOTE: Removal of range from installation position is required.
1.Disconnect power before servicing.
2.Remove oven door, see "Oven
3.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)
4.Remove appropriate side panel (left or right), see "Side Panel" procedure.
5.Remove screws securing hinge to front frame flange.
6.Complete hinge assembly may be removed.
7.Reverse procedure to reassemble.
NOTE: The door hinges are colored coded for ease of installation. The upper spring hook is gold and the lower spring hook is white.
4.Remove screws securing top rear access panel to chassis.
5.Disconnect and label wire terminals from spark module.
6.Remove spark module from secured position.
7.Reverse procedures to reassemble.Gas Valve
NOTE: Removal of range from installation position is required.
1.Disconnect power before servicing.
2.Remove range from installation position, see "Move and/or Replacing Range" procedure.
3.Remove screws securing bottom rear access panel to chassis.
4.Remove screws securing top rear access panel to chassis.
5.Disconnect tubing from gas valve.
6.Disconnect and label wire terminals from gas valve.
7.Remove screws securing gas valve to chassis.
8.Reverse procedures to reassemble.
NOTE: Perform gas leak test.
Regulator
NOTE: Removal of range from installation position is required.
1.Disconnect power before servicing.
2.Slide range forward out of installation position to gain access to components.
3.Disconnect tubing from regulator.
4.Remove screws securing bracket to back of unit.
5.Remove screws securing regulator to support bracket.
6.Reverse procedures to reassemble.
NOTE: When reconnecting supply line to regulator use pipe dope compound to seal the connection.
NOTE: Perform gas leak test.
Rocker Switch
1.Disconnect power before servicing.
2.Remove infinite switch control knobs located on the backguard.
3.Remove backguard, see "Oven Control/Electronic Clock" procedures. (Perform steps 1 – 4.)
4.Remove housing securing rocker switch to the backguard.
5.Label and disconnect wiring and remove switch.
6.Reverse procedures to reassemble.
Indicator Lamps
Indicator lamps include "Hot Surface" and "Element On."
1.Disconnect power before servicing.
2.Remove infinite switch control knobs located on the backguard.
3.Remove backguard, see "Oven Control/Electronic Clock" procedures. (Perform steps 1 – 4.)
4.Remove housing securing indicator lamps to the backguard.
5.Label and disconnect wiring and remove lamps.
6.Reverse procedures to reassemble.
Spark Module
NOTE: Removal of range from installation position is required.
1.Disconnect power before servicing.
2.Remove range from installation position, see "Move and/or Replacing Range" procedure.
3.Remove screws securing bottom rear access panel to chassis.
26 | 16023417 | ©2004 Maytag Services |
