Disassembly Procedures
!WARNING
To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.
Door Removal
•Open door to stop position (approximately 4"), then grasp both sides of the door and lift up off hinges.
•Lay door on a protected surface, liner side up.
•Close door hinges completely to avoid personal injury.
Door Replacement
1.Open door hinges to first stop position and align slots on the door with the hinge arms on the range.
2.Slide door downward onto hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.
NOTE: The oven door on a new range may feel “spongy” when closed. This is normal and will decrease with use.
Gasket and Door Disassembly
NOTE: Door gasket can be replaced by removing door insert clips and sliding gasket out of bottom door insert.
1.Remove oven door, see "Oven
2.Remove screws securing doorframe to liner located at the bottom.
3.Remove side screws securing doorframe to door liner.
4.Remove screws securing door trim at the top.
5.Slide doorframe and glass off liner from the bottom.
6.Remove screws securing door handle to door liner. (Two on the sides and two in front.)
7.Remove screws securing door baffle to liner.
8.Remove screws securing door baffle to window pack.
9.Remove door baffle and insulation wrap.
10.Remove screws securing window pack to liner. (Window pack comes out as an assembly.)
©2004 Maytag Services | 16023417 | 23 |
