Configuration
How to set the Switch Card Data Port
Introduction If you are using the COM ports of the Switch Cards for simultaneous data access, the administrator can adjust the data port settings on any Switch Card. You must match the data port settings of the Switch Card to the remote module.
Procedure
1.Click Hardware tab and select the card to be setup.
2.Click Data Port tab.
3.Set the data port settings as needed. (see Figure 5.18 on the next page) The default settings are listed for reference.
BPS
Databits
38,400
8
Parity
Stopbits
None
1
Note: Confirm that the data settings on the Switch Card, remote module, remote PC, and RAS or Terminal Server all match. If you cannot get data connectivity after insuring that all data settings match see Data Connection Problems in Chapter 6.
