Lucent Technologies 3100, 3000 manual Customer Supplied Equipment, Minimum PC Requirements

Rack Installation

Customer Supplied Equipment

NOTE: DEFINITY ECS telephones are not supplied with either the Switch Cards or the remote modules. These items must be ordered separately. Contact your Lucent Technologies representative for information.

You must supply the following for installation:

DEFINITY ECS two-wire, 24-port TN-2224 circuit pack or the older 16

qport TN2181.

Any additional DEFINITY ECS circuit packs needed (see the DEFINITY Communications System Generic 3, Installation for Single-Carrier Cabinets manual, document #555-230-894, comcode #107595423, for further information).

An adapter to convert to 120 VAC if you are connecting the Rack to a

q240 VAC outlet.

Power and central office line suppresser. Lucent Technologies recommends the 147C AC/CO Line Surge Protector (#8310-006). Contact your Lucent Technologies representative for ordering instructions.

Four 50-pin female connectors (two connectors for every six Switch

qcards)

A computer for installing and using the Switch Management Interface. Minimum requirements as shown in Table 3.0 below:

Processor

RAM

Operating Systems

Disk Drive

Free Disk Space

Minimum

486 DX2 66MHZ

16MB

WIN 95, WIN 98, or Windows NT 4.0

3 ½ Floppy Disk

6.0 MB

Table 3-0. Minimum PC Requirements

Issue 1 October 1998 3-3