Lucent Technologies 3100, 3000 manual How to Install Switch Cards in the Rack, Settings, Procedure

Installing Switch Cards

DIP Each Switch Card is equipped with a four position DIP switch,

Switch all of which should remain in the OFF position.

Settings

Note: If they are NOT all OFF, your Switch Card will not function properly.

How to Install Switch Cards in the Rack

Procedure

1.Carefully slide the card into the chosen slot in the Rack. (see Figure 4.1)

Note: Component side of the card (the side where the LED is mounted)
should face the power supply￿	of the Rack.	￿￿

Figure 4.1. Sliding the Switch Card in the Rack.

2.Push the card until it is completely seated in the connector.

3.Configure and update the new card. (see page 5-13)

4.Change the administrator password through the Switch Management Interface or Terminal Emulation. (see page 5-15)

Issue 1 October 1998 4-3