| 4. | Air in gas lines when | 4. | Continue to hold down control |
|
| installed |
| knob. Repeat igniting |
|
|
|
| operation until air is removed. |
| 5. | Depleted gas supply | 5. | Contact local propane gas |
|
|
|
| company |
| 6. | ODS/Pilot is clogged | 6. | Clean ODS/Pilot or replace |
|
|
|
| ODS/Pilot assembly |
| 7. | Gas regulator setting is not | 7. | Replace gas regulator |
|
| correct |
|
|
OBSERVED | POSSIBLE |
|
| |
PROBLEM | PROBLEM | SOLUTION | ||
|
|
|
|
|
ODS/PILOT lights but flame | 1. | Control knob is not fully | 1. | Press control knob completely |
goes out when control knob is |
| pressed in |
|
|
released | 2. | Control knob not pressed in | 2. | After ODS/Pilot lights keep |
|
| long enough |
| control knob pressed 30 |
|
|
|
| seconds |
| 3. | Safety interlock system has | 3. | Wait 1 minute for safety |
|
| been triggered (if equipped) |
| interlock system to reset. |
| 4. | Manual shutoff valve not | 4. | Fully open manual shutoff |
|
| fully open |
| valve. |
| 5. | 5. | Hand tighten until snug, then | |
|
| loose at control valve. |
| tighten 1/4 turn |
| 6. | Pilot flame not touching | 6. | A) Contact local propane gas |
|
|
| company | |
|
| allows |
| B) Clean ODS/Pilot (See |
|
| cool, causing pilot flame to |
| Cleaning and Maintenance), |
|
| go out. This problem can be |
| or replace ODS/Pilot |
|
| caused by one or both of the |
| assembly |
|
| following: |
|
|
|
| A) Low gas pressure |
|
|
|
| B) Dirty or partially |
|
|
|
| clogged ODS/Pilot |
|
|
| 7. | Control valve damaged | 7. | Replace valve control |
Page 34
